How to realign your Segway Ninebot G30 series E-Scooter

If you’re still having an issue after reading this blog or have further questions regarding realigning your electric scooter feel free to contact the experts at T-Dot Wheels here 

• Place the scooter on a flat surface: 

The first step in realigning your G30 series e-scooter is to place it on a flat surface, such as a driveway or garage floor. This will ensure that the scooter is level and stable while you work on it.

• Check the alignment of the wheels: 

The next step is to check the alignment of the wheels. Look for any signs of uneven wear on the tires or any wobbling or shaking when the scooter is in motion. If you notice any of these issues, the wheels are likely out of alignment.

• Adjust the front wheel: 

To adjust the front wheel, you will need to loosen the bolts that hold the fork in place. The fork is the part of the scooter that holds the front wheel. Use an adjustable wrench to loosen the bolts and then use your hands to move the fork until the wheel is aligned. Tighten the bolts again to secure the fork in place.

• Adjust the rear wheel: 

To adjust the rear wheel, you will need to loosen the bolts that hold the rear axle in place. The rear axle is the part of the scooter that holds the rear wheel. Use an adjustable wrench to loosen the bolts and then use your hands to move the axle until the wheel is aligned, this is typically concealed with reflective stickers. Tighten the bolts again to secure the axle in place.

• Test-ride the scooter: 

After you have finished adjusting the wheels, test-ride the scooter to make sure that it is running smoothly. Pay attention to any wobbling or shaking, and make any additional adjustments as needed.

Be sure to check out our tutorial on How to realign the front tire on your Segway Ninebot G30P

By following these steps, you can realign your G30 series e-scooter and ensure that it runs smoothly and safely. Remember, always check the owner's manual for specific instructions related to your scooter before making any adjustments, as there may be slight variations in the process based on the model and manufacturer.